Housekeeping · Bathroom fixtures

Uneven shower spray? Check mineral buildup on the nozzles

Use the showerhead maker's instructions for gently removing mineral deposits from the spray nozzles.

AI-edited · Human admin approved

Wikimedia Commons · Nicole-Koehler / Wikimedia Commons, CC BY-SA 3.0; original image, no edits. Source: https://commons.wikimedia.org/wiki/File:Shower_head.JPG · CC BY-SA 3.0 ↗

Minerals in water may collect around showerhead nozzles. Delta recommends rubbing deposits from its Touch-Clean nozzles, while certain non-Touch-Clean models may be cleaned with a diluted vinegar solution. This does not make vinegar safe for every finish, so check the specific model first.

Your try-it-at-home checklist

0 / 6 done

Turn off the shower and identify the showerhead model and finish.
For manufacturer-approved rubber rub-clean nozzles, loosen deposits gently with your fingers or a soft cloth.
For other models, consult the instructions for permitted cleaners, dilution and contact time; Delta describes a 1:1 vinegar-and-water mixture for some products.
Do not apply unapproved acid cleaners, chlorine bleach, abrasive brushes or needles, and never mix cleaners.
Rinse thoroughly, run water briefly and check the spray. Do not overtighten fittings if you notice leakage.
If spray remains weak or parts are damaged, follow the model instructions or consult a qualified technician.

Your try-it-at-home checklist

Further reading

You may also like

Six steps to rotate—not flip—a Sealy Posturepedic mattress

Six steps to clean Andersen sliding patio-door tracks and rollers

Six steps to reduce kitchen-sponge cross-contamination