Living items · 로봇청소기 관리

Roborock S8 MaxV Ultra main brush care in 6 steps

Remove tangles from the two main brushes and refit bearings and the cover safely.

AI-edited · Human admin approved

Roborock Support

Official source: Roborock S8 MaxV Ultra main brush care in 6 steps

Link card to Roborock Support source

Based on section D1 of the official S8 MaxV Ultra with Refill and Drainage System manual. Other variants may differ.

0 / 6 done

1. Stop cleaning, switch off the robot and disconnect dock power before maintenance.
2. Turn the unit over on a stable surface and release the two main-brush-cover latches.
3. Remove both main brushes, then separate bearings, caps and hair-blocking rings as the manual shows.
4. Clear hair and dirt from both brush ends and rings; do not use corrosive cleaners or disinfectants.
5. Reassemble in the prescribed order, secure bearings and reinstall both brushes.
6. Make sure the cover clicks securely into place. Roborock recommends cleaning every two weeks and replacement after 6–12 months.