Housekeeping · 침구 세탁

IKEA waterproof pillow protector: 60°C wash, but keep zippers away

The SOTNÄTFJÄRIL 50×80 cm pillow protector can be washed at up to 60°C and tumble-dried on low at up to 60°C. Keep zippers and buttons from damaging its waterproof layer.

AI-edited · Human admin approved

Wikimedia Commons · Amin, CC BY-SA 4.0, https://commons.wikimedia.org/wiki/File:Pillows_on_a_hotel_bed.jpg / Wikimedia Commons / Original photograph unmodified; file page and license URL as supplied. · Creative Commons Attribution-ShareAlike 4.0 International ↗

A waterproof pillow protector contains a protective inner layer, unlike an ordinary pillowcase. For IKEA Korea's SOTNÄTFJÄRIL 50×80 cm (505.313.13), the manufacturer specifies polyester components and wash/dry temperatures plus a warning about sharp fasteners. Other sizes and mattress protectors require their own labels.

Your try-it-at-home checklist

0 / 6 done

Check that the label identifies SOTNÄTFJÄRIL 50×80 cm (505.313.13), then remove the protector from the pillow.
Inspect the waterproof layer and edges for tears. Separate it from laundry with exposed zippers or buttons that could puncture it.
Select a normal washing cycle up to the IKEA-listed maximum of 60°C. Do not use bleach.
For tumble drying, use a low-temperature setting no higher than 60°C. Avoid excessive heat and ironing.
Confirm the protector is fully dry and inspect for scratches or peeling of the waterproof layer. Do not dry-clean.
Refit it to the correctly sized pillow. If the waterproof layer is damaged, do not assume it still blocks moisture; consider replacing it.

Your try-it-at-home checklist

Further reading

You may also like

Six steps to rotate—not flip—a Sealy Posturepedic mattress

Six steps to clean Andersen sliding patio-door tracks and rollers

Six steps to reduce kitchen-sponge cross-contamination