Housekeeping · 세탁기 관리

Drain the water before cleaning a washer's pump filter

Opening the filter immediately can spill water. Check your model, unplug it, drain the remaining water, clean the filter and check for leaks.

AI-edited · Human admin approved

Wikimedia Commons · Fanti Salms / Wikimedia Commons, CC BY-SA 3.0, unmodified original. · CC BY-SA 3.0 ↗

Not every front-loader has a user-serviceable filter, and its location varies. Follow your manual and let any hot water cool. If water cannot be drained or the filter is stuck, request service rather than forcing it.

Your try-it-at-home checklist

0 / 6 done

Confirm your model has a user-cleanable drain pump filter and stop the machine with the drum empty.
Switch off and unplug. After a hot wash, wait until residual water cools.
Put towels and a shallow basin below the lower service door; keep water away from sockets.
If present, slowly uncap the emergency drain hose and empty remaining water before securely replacing its cap. Do not pull the hose too far.
Only after draining, remove the filter in the manual's direction, clear lint and coins, and gently wash it with water and a soft brush. Avoid electrical parts.
Securely refit the filter and hose cap, close the door and check for leaks during a small drainage test. Stop use if abnormal.

Your try-it-at-home checklist

Further reading

You may also like

Six steps to rotate—not flip—a Sealy Posturepedic mattress

Six steps to clean Andersen sliding patio-door tracks and rollers

Six steps to reduce kitchen-sponge cross-contamination