Living items · 사무용품 관리

Shredder maintenance: never use aerosol oil; check your Fellowes model

Fellowes recommends regular lubrication for cross-cut and micro-cut shredders, but not strip-cut models. Avoid aerosol and petroleum-based lubricants because of fire risk; use maker-approved oil or sheets.

AI-edited · Human admin approved

Wikimedia Commons · Manuel Schmalstieg / CC BY 4.0 / Wikimedia Commons; https://commons.wikimedia.org/wiki/File:Small_paper_shredder.JPG ; unmodified · Creative Commons Attribution 4.0 International ↗

Maintenance depends on shredder type. Fellowes support says cross-cut and micro-cut cutters need regular oiling, often when the waste bin is emptied, while strip-cut machines do not. Controls and oiling sequences vary; the actual model manual and safety guidance take precedence.

Your try-it-at-home checklist

0 / 6 done

Identify the shredder model and whether it is strip-cut, cross-cut or micro-cut; find the official manual.
Fellowes says strip-cut machines do not require oiling. For cross-cut/micro-cut, check the recommended frequency and approved lubricant.
Turn the unit off and unplug it before emptying the bin or clearing debris. Never reach into the paper feed with hands or tools.
For compatible Fellowes models, use maker-approved non-aerosol shredder oil or designated lubricant sheets. Do not use WD-40 or petroleum-based spray products.
Follow the exact manual sequence. Some models call for a thin line of oil across the entry while OFF then a short reverse run; others use a lubricant sheet.
After maintenance, follow the manual to check normal operation. Stop using the machine and contact service if it overheats, makes abnormal noises or continues to jam.

Your try-it-at-home checklist

Further reading

You may also like

Six steps to clean, air-dry and store Hunter rubber rain boots

Six steps for safe Anker power-bank storage and charging

Six steps to clean, condition and store a Coach leather bag