Living items · 공기청정기 필터 교체

Replace and reset a Dyson Pure Cool TP01 filter in six steps

Follow model-specific unplugging, filter installation and remote-control reset guidance.

AI-edited · Human admin approved

Dyson Support

Official source guidance from Dyson Support

Original source link for Replace and reset a Dyson Pure Cool TP01 filter in six steps

These instructions apply to the TP01; different Dyson purifier models can have different filter and reset procedures.

0 / 6 done

Check the filter replacement alert and obtain a compatible TP01 replacement filter.
Stop the machine and unplug it from the power outlet.
Press the two release buttons and lift off the loop amplifier.
Remove the old filter and seat the new filter in its housing; do not attempt to wash a non-washable replacement filter.
Lower the loop assembly until it clicks into place, then reconnect power.
Hold the Standby ON/OFF button on the remote for about six seconds and wait for the rotating display pattern to finish. Consult model support if the alert persists.