Housekeeping · 건조기 관리

Dryer lint screen: remove lint each load, wash residue only as needed

Remove lint from the dry screen after every load. If detergent or softener leaves a film, follow the model manual for gentle washing, then dry the screen fully before refitting.

AI-edited · Human admin approved

Wikimedia Commons · BD2412 / Creative Commons Attribution-ShareAlike 3.0 Unported (https://creativecommons.org/licenses/by-sa/3.0/) / Wikimedia Commons original: https://commons.wikimedia.org/wiki/File:Dryer_lint_screen.jpg; original image unmodified · Creative Commons Attribution-ShareAlike 3.0 Unported ↗

Whirlpool and Maytag advise cleaning lint after each load without first wetting the screen; wet lint is harder to remove. Some models permit an occasional nylon-brush wash for residue buildup. Never run a dryer with a damaged, missing or improperly seated screen.

Your try-it-at-home checklist

0 / 6 done

Stop the dryer and let it cool before checking your model manual for the screen's location and removal method.
After each load, remove the screen and roll the dry lint away with your fingers. Do not wet the lint first.
Inspect the mesh and frame for tears or warping. Replace a damaged filter with the manufacturer-approved part.
If detergent or softener film clogs the mesh and the manual permits it, gently scrub both sides using warm water, liquid detergent and a soft nylon brush; rinse thoroughly.
Blot the washed screen with a clean towel and let it dry completely before firmly reinstalling it. Never operate the dryer without its screen.
If drying remains slow or airflow seems restricted, follow manufacturer guidance for vent or duct servicing, using a qualified technician when appropriate.

Your try-it-at-home checklist

Further reading

You may also like

Six steps to rotate—not flip—a Sealy Posturepedic mattress

Six steps to clean Andersen sliding patio-door tracks and rollers

Six steps to reduce kitchen-sponge cross-contamination